The Type-C master and the -pad of its side are the power input, and the 5V input voltage, B lithium battery positive plate, B-lithium battery negative electrode.
OUT , OUT - Take the load, such as moving the roll-off board is negative or other load. Connect the battery to B , B-, insert the phone charger to USB female seat, red light is on charging, blue light is bright.
When the input is input, the current is obtained from the power supply output.
If no power is not connected, the current is obtained from the battery, and the battery voltage is lower than 2. 5V, the output is automatically turned off.
Precautions:
When you first access the battery, you may have an output voltage output without voltage, you need to access 5V charge and activate the protection circuit on the power input.
When powering with a mobile phone charger, you must output 1A or more, otherwise it may not be charged normally.
The load on the OUT side should be disconnected when charging.
Note: The module only work with a USB to USB-C, don't support USB-C to USB-C charge
About this item
Input interface: Type-C USB.
Battery overcharge lifting voltage: 4.00 V
Battery: over-current protection current 3 A
Maximum charging current output: 1000 ma
Light state: no load the light not bright, red light for recharging, is full of blue light.Material:Copper Power Mode:USB Charging Operating Voltage:≤36V Battery Properties:Without Battery
